Reply
 
Thread Tools Display Modes
  #1   Report Post  
Dave
 
Posts: n/a
Default Need help from the radio gods; will sacrifice chicken if necessary

Hello radio gods,
I just put in 2 blaupunkt speakers and a CD player from my old car
that was junked into the car I just bought (a '90 honda civic).

there are only 2 speakers (front left and right). the old ones in the
civic were blown so i put the blaukpunkts (50 watts) in from my old
car. the tape player in the civic also was bad so I put the Goodmans
CD player (cheap but then I don't need anything fancy) in from my last
car.

Everything seems to work, except for two problems.

1) When I accelerate and the radio is on, there's a weird high pitched
buzzing noise.

2) If I raise the volume to a higher level, the signal cuts out /
skips. It does this for radio or CD.

Perhaps related to this: I connected front left and front right
speakers correctly, but I noticed that if I connected the Pos and Neg
Rear left / right wires together (those coming out of the CD player)
that the signal from the front speakers sounded better - louder and
clearer. So I tied the wires together (rear left pos to rear left
neg, ditto for rear right). I ask forgiveness if this was a moronic
thing to do.

Anyway I'd like to fix this problem.

I have the CD player manual. It reads

Voltage: 12V
Polarity: Negative Ground Only
Speaker Impedance: 4 ohm - 8 ohm
Max Output Power: 4 * 10W MPO

thanks in advance
  #2   Report Post  
The Lizard
 
Posts: n/a
Default Need help from the radio gods; will sacrifice chicken if necessary

Dave wrote:
I connected front left and front right
speakers correctly, but I noticed that if I connected the Pos and Neg
Rear left / right wires together (those coming out of the CD player)
that the signal from the front speakers sounded better - louder and
clearer. So I tied the wires together (rear left pos to rear left
neg, ditto for rear right). I ask forgiveness if this was a moronic
thing to do.


It was moronic. Undo this, it's most likely the cause of your problem.

Also, make sure none of the speaker wires are grounded, and that the
radio is properly grounded.


--
------------------------------------------------------------------
| Lizard | thelizman1221.yahoo@com |
------------------------------------------------------------------
| teamROCS #007 / Technical Director / Founding Member |
------------------------------------------------------------------
| The TeamROCS Forum http://www.teamrocs.net/forum/ |
| |
| iAndrew The Place Where I Pretent To Give A **** |
| http://www.geocities.com/thelizman1221/ |
------------------------------------------------------------------

Reply
Thread Tools
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
How can I capture Internet radio broadcasts on MP3? Bob Boudewyns General 2 January 10th 08 08:49 PM
On a mission : finding a basic radio Olivier General 4 January 4th 04 09:39 PM
BPM Studio, DMP Radio Automation, Jazler, Megamix, DJ all, all VSTI's,AKAI Sample CDs, other TEL General 0 January 1st 04 06:10 PM
radio kaput - light but no sound NJ Beach Bum Car Audio 2 July 9th 03 11:40 PM
Aux-IN 2003 Envoy Radio CraigM Car Audio 0 July 3rd 03 02:31 AM


All times are GMT +1. The time now is 05:34 AM.

Powered by: vBulletin
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AudioBanter.com.
The comments are property of their posters.
 

About Us

"It's about Audio and hi-fi"