About Us

"Geoley" wrote in message servers.com...
"Mike Rivers" wrote in message
news:znr1097620378k@trad...

In article
writes:

The manual only lists one part (PA-372) for the reproduce electronics
card. The only place it mentions IEC or NAB is in the parts list for
Maintainence and repair, where it gives two different part numbers for
1/2 inch 15ips test tape - one for NAB and one for IEC.

It may be that the equalization is fixed - if it's a European machine,
it will be set up for IEC, if it's an American machine, it'll be NAB.
You may need to look at the schematic and see if there's a note about
different parts or jumpers. I'm pretty sure there's an NAB/IEC switch
on my Otari MX-55, but that doesn't mean there's one on the 5050.

--
I'm really Mike Rivers )
However, until the spam goes away or Hell freezes over,
lots of IP addresses are blocked from this system. If
you e-mail me and it bounces, use your secret decoder ring
and reach me he double-m-eleven-double-zero at yahoo

Mike: I have an Otari MX5050 BII 1/4" 2 track and it does have a switch on
the back apron
to switch between IEC and NAB.

George

I have a mx5050 1/4" 2 track as well. That's got the switch. The 1/2"
8 track doesn't though.

Thread Tools
Show Printable Version
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Just checking if posting works	Balaji	Audio Opinions	2	December 20th 04 12:25 AM
"Average" PC speakers for checking mixes?	Jay Levitt	Pro Audio	14	October 3rd 04 07:52 AM
"Average" PC speakers for checking mixes?	Jay Levitt	Pro Audio	0	October 1st 04 06:39 AM
Checking out a used DAW	Willie K.Yee, M.D.	Pro Audio	2	August 27th 04 01:40 PM

Menu

About Us