Home |
Search |
Today's Posts |
#1
![]()
Posted to rec.audio.pro,rec.audio.tech
|
|||
|
|||
![]()
Good day group,
Perhaps someone can clear something up for me. I just came into possession of some rather large 3-way speakers and I took the woofers and midrange and tweeters out to have a look-see. The hots for the mids and tweeters are connected from the terminals in back of the cabinets in series respectively with 10 mfd and 4.7 mfd electrolytic caps to pots on the cabinet face and then to the drivers. The hots for the woofers are directly connected to the speaker wire terminals, as are the grounds for all the speakers. The question I have arises from how the mids are wired. The woofers have a '+' and '-' stamped near the connector lugs, so its easy to tell which wire goes where inside the cabinet. The mids have a red band near one lug and the tweeters have a red dot near one lug. I am assuming that red means hot or positive and 'no red' means ground or minus. The confusion arises from the fact that the grounds coming from the amp are connected to the red side of the connector lugs on the mids. The tweeters have the hot, or positive, wire connected to the red side and the woofers have the hot, or positive, wire connected to the side stamped with the '+'. I checked the woofer against the midrange with 1.5 volt battery and the red side on the mid corresponds to the '+' on the woofer. Connecting the plus side of the battery to the red side of the mid caused the cone to move out, and connecting the plus side of the battery to the '+' on the woofer moved the cone in the same direction. But the the speakers were wired inside with the negative wire from the amp going to the red or positive side of the midrange driver. Is it normal for a 3-way speaker box to be wired this way? I would think that all the individual drivers in a box should be phased the same. I am basing that on absolutely nothing but pure logic and a knowledge of how a speaker moves air to create sound and that if two speaker boxes are connected out of phase, their individual output of sound would tend to cancel each other out. Can anyone shed some light on this? Thanks, Jack Beautiful Sunny Berkeley |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Speaker phase question | Tech | |||
Speaker phase question | Pro Audio | |||
Phase splitter question | Vacuum Tubes | |||
Speaker Phase? | Car Audio | |||
Speaker Wiring affects phase relationships | Car Audio |