I just acquired a pair of 8w6's at a garage sale for cheap and had some
wiring questions. Along with the speakers, I bought an MTX Thunder
801D amp on the cheap side as well. Looking on MTX's page, here are
the specs.
* Power measured at 14.4 Volts DC:
* 800 Watts x 1 into a 2 Ohm load
* 400 Watts x 1 into a 4 Ohm load
* RMS Power measured at 12.5 Volts DC:
* 500 Watts x 1 into a 2 Ohm load with less than 1% Thd+N
* 250 Watts x 1 into a 4 Ohm load with less than 1% Thd+N
* Signal to Noise Ratio: 100dB A-Weighted
* Damping Factor: 100
* Frequency Response: 20Hz-200Hz ± 3dB
* Maximum Input: 8Vrms
* Thunder EQ: Variable Bass Boost (0-18dB) centered at 40Hz
* Crossover: Variable 40Hz to 200Hz, 24dB/Octave Low Pass
* Dimensions: 11.5" x 9.75" x 2.1" (29.3cm x 24.8cm x 5.3cm)

What I can't figure out is if the subs will work with this amp. I
understand that the subs can only be wired in either a 1.5 or 6 ohm
configuration, and neither are presented by the amp, so am I just out
of luck?

Any help would be appreciated!