This could be a killer SCA 35 project for somebody.

First, what I don¹t have:

The ³cage². You probably wouldn¹t want one since this will be so pretty
when done.
New original knobs.
The back chassis panel. It was at the powder coaters and I forgot about
it and they went out of business.
The quad cap (that apparently is no longer in production, but I do have
a 3-section cap and an additional cap that will allow you to do the same
thing)

This is what I have:

A mint copy of the Instruction/Construction manual

Basically an unbuilt Dynakit SCA-35, which, unfortunately is in a state
of disarray so I¹m including all of the stuff I have that even looks
like it might belong.

I have had the chassis parts, that I have, powder coated in gloss black.
The faceplate is still in the plastic and ³new². The boards are bare and
I think I have almost all of the internal hardware.

I am including a whole bunch of tight tolerance resistors and stuff I
had left over from re-doing a ST 35 so a lot of it should be the same.

I have some really neat black aluminium knobs that I think are much more
attractive than the originals. I will throw in some originals that are
good but used condition.

The (2) Z 565 and the PA 774 transformers are pulls and the leads have
been cut but they are in excellent condition.

I would like to sell this as a ³kit² all together without resorting to
eBay.

$300.00 plus shipping from 78229 for the whole set-up.

If you have questions or you would like a picture, please send email.






Thanks,

jp