Am modifying a 19" nest unit containing 10 of these excellent modules
plugged into their motherboard (backplane), and running off +/-16.5V dc with
a Centre rail for Active component supplies and +5V dc for Logic
devices/LEDs.
Each channel module has two 32-pin Euroconns, most of whose functions I
understand, but I am at a loss regarding the following:

Upper Euroconn, dedicated to card B -
pins 23 and 22 (Line level i/p). How can this optional i/p pair be harnessed
by external switching?
pins 3 and 2. (Mic Hi/Lo select) Are pins 3 and 2 to be strapped? We need
max available i/p gain for dynamic mic use.
pin 1 (Line select). Should this be permanently tied to pin 8 of card A?

Lower Euroconn, dedicated to card A -
pin 8 (Logic). Are the channels all bussed together at this pole, and then
connected externally to some switch? If so, how?

Hope someone can help out.
Thanks
Jim

[guillaume]

Hi Jim,

i owned a PQ1253 and i am looking for the pinouts. You seem to know this.
I don't have it yet, maybe it is written inside on the pcb but i am preparing myself to not have it written...
I think it will be a great unit, i am keen of having it. I need to do the PSU, and mount it in a rack or something like this.
I really need those pinouts, hope you know

Bests
Guillaume

You guys might want to try pinging Conrad Slater over on the RAMPS
board--he's had a Calrec console that he's used for many years and he
knows it and the Calrec folks very well.

Philip Perkins