I was wondering if anyone could give me some input or advice on using
a Yamaha 4416 as a control surface for a Pro Tools session. I have a
Digi 001 setup and I see on the Yamaha website that there is a MIDI
remote template to make the 4416 work with Pro Tools. However, I am
not sure on the details on setting up the two together. Listed below
are the instructions from Yamaha's web site. Just not sure what in
OMS setup I might need to do and if this is even something that I want
or can use. Also, I am not to sue on how to load the bulk MIDI data
file into the 4416. Any help or input would be most welcomed. Thanks

--tracy

Yamaha AW4416 MIDI Remote Template

AW4416 --REMOTE -- Pro Tools Software

Installation
This template is stored in bulk MIDI data format. To install the
template, use a MIDI sequencer to send the "4416pt.mid" bulk data file
to the AW4416.

Feature Overview
This template allows you to remotely control the track volumes of
Digidesign Pro Tools software via the AW4416.

Main Functions
Direct control of Pro Tools track faders is possible using the 16
faders of the AW4416.

Detailed Template Settings
Faders of Remote Bank A is assigned to audio channels 1-16. ON/OFF
buttons are assigned to MUTE.(The LED will be displayed in reverse to
usual AW display.

Setup

1.
Using a MIDI cable, connect the MIDI OUT/THRU jack of the AW4416 to
the MIDI IN jack of the MIDI interface connected to Pro Tools.

2.
In Pro Tools, set the controller to CS-10.