I'm working on a project to install a car computer in my car. The next step
is to put the LCD screen in the dash. I removed a double DIN spaced CD
player and its going in there. To make it fit better I removed the "guts"
of the lcd screen from its case and I want to attach this to the original CD
player bezel and just install the bezel w/ the LCD screen attached to it.

I ran into a snag when I started figure out how to attach the screen to the
bezel. I purchased an extra one to play with so I don't mess up the
original, but I set the bezel face down, then I put the LCD screen face down
on the bezel, but I don't know how to attach it.

I thought about fiberglassing brackets by molding them to the back of the
screen then epoxying them to the bezel and sliding the screen down. Or
perhaps hot glue gunning it in some how.

I'm looking to see if anyone has any ideas on this part. I've included a
link to a picture that shows where I am:

http://www.warnockinc.com/Projects/LCD3.jpg

Any suggestions would be greatly appreciated!