How can I attach a TO3P device to the TO3 socket on my MOSFET testing
meter?

Is there a way to make a fixture into which the 3 pins on the TO3P can
plug and which has output pins to match a TO3 socket?

The Hitachi TO3P 2SK1056/2SJ160 are mostly identical to the old TO3
2SK134/2SJ49 MOSFETs. But, how to test the newer TO3P devices using the
nice TO3 test meter I have here?

Thanks...............

lid wrote:

How can I attach a TO3P device to the TO3 socket on my MOSFET testing
meter?

Is there a way to make a fixture into which the 3 pins on the TO3P can
plug and which has output pins to match a TO3 socket?

The Hitachi TO3P 2SK1056/2SJ160 are mostly identical to the old TO3
2SK134/2SJ49 MOSFETs. But, how to test the newer TO3P devices using the
nice TO3 test meter I have here?

You'll have to improvise a jig.

Have you got a defective TO-3 device ? Saw the top off the can - remove the
die attach leads and wire the internal pins to a socket that fits the TO-3P

Graham

Pooh Bear wrote:

lid wrote:

How can I attach a TO3P device to the TO3 socket on my MOSFET testing
meter?

Is there a way to make a fixture into which the 3 pins on the TO3P can
plug and which has output pins to match a TO3 socket?

The Hitachi TO3P 2SK1056/2SJ160 are mostly identical to the old TO3
2SK134/2SJ49 MOSFETs. But, how to test the newer TO3P devices using the
nice TO3 test meter I have here?

You'll have to improvise a jig.

Have you got a defective TO-3 device ? Saw the top off the can - remove the
die attach leads and wire the internal pins to a socket that fits the TO-3P

Graham

Thanks. I already did saw off the top of a blown out TO-3. Any suggestions on
how to attach leads to it? And, where do I get a socket for the TO-3P.

lid wrote:

Pooh Bear wrote:

lid wrote:

How can I attach a TO3P device to the TO3 socket on my MOSFET testing
meter?

Is there a way to make a fixture into which the 3 pins on the TO3P can
plug and which has output pins to match a TO3 socket?

The Hitachi TO3P 2SK1056/2SJ160 are mostly identical to the old TO3
2SK134/2SJ49 MOSFETs. But, how to test the newer TO3P devices using the
nice TO3 test meter I have here?

You'll have to improvise a jig.

Have you got a defective TO-3 device ? Saw the top off the can - remove the
die attach leads and wire the internal pins to a socket that fits the TO-3P

Graham

Thanks. I already did saw off the top of a blown out TO-3. Any suggestions on
how to attach leads to it?

Solder ?

And, where do I get a socket for the TO-3P.

Any single-in-line socket with the correct pitch that accepts the leads ?

Molex / AMP / Panduit will have something.

Try Mouser etc.


Graham