Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
On Sat, 16 Aug 2003 13:45:55 GMT, The Wobulator
wrote: Hi, I'd like to use wireless speakers for my rear channel sound instead of having speaker wires run along the base boards. However, all the ones I've seen use the line out and not the speaker out. The rear channel on my AV receiver is amplified and would probably damage the wireless transmitter. What I need is, is something to step-down the amplified output. Does anyone know if something like this exists? Or does anyone know of a wireless speaker set that would work? Suggestions welcome! Get a pair of speaker-to-line adapters from any auto-audio store. Of course, all of the wireless remote speakers are mediocre. Kal |
#2
![]() |
|||
|
|||
![]()
In , on 08/17/03
at 04:21 PM, The Wobulator said: Hi, I'd like to use wireless speakers for my rear channel sound instead of having speaker wires run along the base boards. However, all the ones I've seen use the line out and not the speaker out. The rear channel on my AV receiver is amplified and would probably damage the wireless transmitter. Many A/V receivers have auxiliary line out jacks for the rear channels. What I need is, is something to step-down the amplified output. Does anyone know if something like this exists? Or does anyone know of a wireless speaker set that would work? Suggestions welcome! There is a device called a "Z-coupler" that will reduce a speaker level signal to line level. (note that not everyone calls knows them by this name) Some audio stores have them, but it is more likely that an autosound shop will stock Z-couplers. If you have the construction skills, two resistors per channel will do the job. If the wireless transmitter has an input gain control, it will probably have enough range to operate from your speaker terminals. The biggest danger would be for your A/V receiver because the shields (outside contacts on the RCA plugs) are usually common to the left and right channels of the transmitter. This means that you must take care to connect the inner conductor (the pin on an RCA plug) to the positive terminals of your amplifier. It is very rare, but some receivers will not like the common ground provided by the wireless transmitter. That said, I don't like wireless speakers. They are not truly wireless because they need AC power, they are typically low quality speakers, and there are often unsolvable radio interference problems. If you have wall-to-wall carpet, a pair of speaker wires can usually be run between the tack strip and the wall. ----------------------------------------------------------- SPAM: wordgame:123(abc):14 9 20 5 2 9 18 4 at 22 15 9 3 5 14 5 20 dot 3 15 13 (Barry Mann) [sorry about the puzzle, SPAMers are ruining my mailbox] ----------------------------------------------------------- |
Reply |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Why do the speakers sound so bad? | Car Audio | |||
2 channel head unit to four speakers does not work right | Car Audio | |||
Is front center channel sufficient? | Audio Opinions | |||
AER Pisces PB-651 V2.0 speaker review | Audio Opinions | |||
Main speakers with builtin subwoofer - How to configure receiver? | Audio Opinions |