Home |
Search |
Today's Posts |
#1
![]()
Posted to rec.audio.pro
|
|||
|
|||
![]()
Where can I get a replacement Board for an Event Electronics Tuned
Reference Monitor TR-5? One of my TR5s went bad, with very low volume, so I cracked it open (after swapping speakers, to make sure that was not the problem). Unfortunately, I was not able to find a schematic online. At first I thought maybe the LM3886TF audio ICs went bad, but after doing some signal tracing, it appears the input signal isn't making it to differential input pins 9 and 10, on either of the ICs. Or at least, the signal is much attenuated from the input level. Also, the heat sink that the LM3886TFs are bolted to, is getting a little bit warm, and the +/-24 Volt rails are at pins 1 and 4. So this makes me think maybe the LM3886 chips are NOT the culprit here (they also do not look melted, damaged, or cracked). Perhaps there is a bad passive component in the cross-over circuitry? Or maybe the TL072C Opamp is bad? At any rate, does anyone know where I can get a replacement board? Does Event still support this older model? Could they replace, or at least troubleshoot this board? Or does someone have a schematic? I'm lost in the forest without one! ![]() --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
McIntosh Driver Board Transistor Replacement | Tech | |||
Replacing Amp In Event TR-6 Monitor? | Pro Audio | |||
Event TR-6 Monitor Is Cooking Tweeters?!?! | Pro Audio | |||
PLEEZE HELP! Having a problem with an EVENT Studio Precision 6 Monitor.... | Pro Audio | |||
How to split monitor out from board into 2 monitor amps? | Pro Audio |