Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
Wondering if anyone has or had any experience with this.
I hooked up my Sansui G22000 receiver with Infinity Composition Overture 3's. They are powered floor standing speakers. Now the protection mode is coming on at -24 on the volume level on the Sansui. I put a pair of non powered Sansui speakers SPX-7000 and it went well past there with no protection kicking in. Not going any higher than that as the SPX7000 speakers can't handle the G-22000 beast. I also have a HK reciever and a Sansui G7000 which both have no challenges with the O3's. Any ideas on what is going on as I am convinced it is in the G-22000. I can't find anything that would say powered speakers would be a challenge. Only that if you use 4 ohm speakers you can not run another set of speakers on top of that. The Overtures are rated at 8 ohms and I had no other speakers connected either so no challenge there. Scratching head..... |
Reply |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
self powered speakers | High End Audio | |||
Powered Speakers versus Powered Mixers | Pro Audio | |||
D.A.S powered speakers | Pro Audio | |||
Powered Speakers? | General | |||
M-Box with Powered speakers | Pro Audio |