[Jacques E. Bouchard]

"Richard Crowley" wrote in
:

"Jacques E. Bouchard" wrote ...
So how would I make a cable to use the Azden with a consumer
camcorder?

XLR pin 1 (mic ground/shield) to mini-phone sleeve (camcorder ground)
XLR pin 2 (mic balanced + side) to mini-phone tip (camcorder left
channel) XLR pin 2 (mic balanced + side) to mini-phone ring (camcorder
right channel) XLR pin 3 (mic balanced - side) to mini-phone sleeve
(camcorder ground)

Ideally, you would use a capacitor to block the "plug-in power"
from the camcorder from getting into the microphone.

Circuit diagrams on my website...
http://www.rcrowley.com/CamAdapt.htm

Thanks Richard, very useful tip.


jaybee