[Gareth Magennis]

wrote in message
...
Can anyone tell me which Omron relay to use to replace the ones in a
Tascam MS-16?
Thanks, Andy


If nobody knows its usually quite easy to find out for yourself.
Remove one from the machine and it will no doubt have the coil voltage
stamped on it. Measure the coil resistance with a meter, and the pin
spacing/configuration in miilimeteres.

Try this:
http://uk.farnell.com/jsp/search/bro...ron+relay&Ntx=


Refine your search coil voltage, number of poles, till you get the right
ballpark. Look for a similar looking one (move the mouse over the picture
to amplify) and check the specs, particularly the coil resistance. Check
the pin configuration by clicking on the part number and looking at the
technical data sheet.

A bit long winded and a lot quicker and easier if you have a paper
catalogue!



Gareth.