[west]

I have a pair of Infinity RS-IIIb. In moving the bottom tilt stand was lost.
Does anyone know where I can buy a pair (Infinity-NG). Perhaps someone has
a picture-diagram of them and can sell me the plans so I can have them
duplicated (I'm a klutz at building things). Any suggestions would be most
appreciated. Thank you.

Cordially,
west

[JANA]

Have you tried to contact the manufacture directly?

--

JANA
_____


"west" wrote in message
news:hrHjh.456$cI.153@trnddc05...
I have a pair of Infinity RS-IIIb. In moving the bottom tilt stand was lost.
Does anyone know where I can buy a pair (Infinity-NG). Perhaps someone has
a picture-diagram of them and can sell me the plans so I can have them
duplicated (I'm a klutz at building things). Any suggestions would be most
appreciated. Thank you.

Cordially,
west

[Trevor Wilson]

"west" wrote in message
news:hrHjh.456$cI.153@trnddc05...
I have a pair of Infinity RS-IIIb. In moving the bottom tilt stand was
lost.
Does anyone know where I can buy a pair (Infinity-NG). Perhaps someone
has
a picture-diagram of them and can sell me the plans so I can have them
duplicated (I'm a klutz at building things). Any suggestions would be most
appreciated. Thank you.

**I assume you mean that BOTH stands were misplaced? Obviously, if you have
one, then you can fabricate a second. From memory, you need a flat piece of
MDF, around 40cm X 40cm. To angle the speaker back, you need a second piece
of MDF, the same size as the footprint of the speaker, chamfered at an angle
of approximately 5 - 10 Degrees. IT's been awhile since I've seen a pair,
but that is how I recall the stand is configured.


--
Trevor Wilson
www.rageaudio.com.au



--
Posted via a free Usenet account from http://www.teranews.com

[west]

"Trevor Wilson" wrote in message
.. .

"west" wrote in message
news:hrHjh.456$cI.153@trnddc05...
I have a pair of Infinity RS-IIIb. In moving the bottom tilt stand was
lost.
Does anyone know where I can buy a pair (Infinity-NG). Perhaps someone
has
a picture-diagram of them and can sell me the plans so I can have them
duplicated (I'm a klutz at building things). Any suggestions would be
most
appreciated. Thank you.

**I assume you mean that BOTH stands were misplaced? Obviously, if you
have
one, then you can fabricate a second. From memory, you need a flat piece
of
MDF, around 40cm X 40cm. To angle the speaker back, you need a second
piece
of MDF, the same size as the footprint of the speaker, chamfered at an
angle
of approximately 5 - 10 Degrees. IT's been awhile since I've seen a pair,
but that is how I recall the stand is configured.


--
Trevor Wilson
www.rageaudio.com.au

Thanks Trevor, I'll keep your post on file but still check around a bit. I'm
missing both & Infinity is no help.

Cordially,
west



--
Posted via a free Usenet account from http://www.teranews.com