[Phil W]

"John Doe" :

FWIW... Before upgrading my main monitor last week, I tried the
built-in speakers and did not notice the noise. But difficult to
hear anything on those built-in monitor speakers.

The HDMI audio extractor (Tripp Lite P130-000-AUD4K6) should tell
that one. If there is still noise, through the 3.5 mm stereo output
jack, I will assume the SPDIF on the extractor link would not work
either, that the noise is introduced before that point.

Good luck, that it helps.

I will lose the SoundBlaster equalizer software, using HDMI audio,
but I suppose there is a replacement.

IF you´re using Windows, you might want to check out:
https://sourceforge.net/projects/equalizerapo/
in conjunction with
https://sourceforge.net/projects/pea...apo-extension/

as a "system-wide" EQ - can be activated and DEactivated easily.


Phil

[John Doe[_2_]]

"Phil W" wrote:

"John Doe" :

I will lose the SoundBlaster equalizer software, using HDMI
audio, but I suppose there is a replacement.

IF you´re using Windows, you might want to check out:
https://sourceforge.net/projects/equalizerapo/
in conjunction with
https://sourceforge.net/projects/pea...apo-extension/

as a "system-wide" EQ - can be activated and DEactivated easily.

Thanks. This is preliminary, but... I especially needed the "Pre
Amplifying" function. Was not getting enough volume out of my
system.

[John Doe[_2_]]

John Doe wrote:

"Phil W" wrote:
"John Doe" wrote:

I will lose the SoundBlaster equalizer software, using HDMI
audio, but I suppose there is a replacement.

IF you´re using Windows, you might want to check out:
https://sourceforge.net/projects/equalizerapo/
in conjunction with
https://sourceforge.net/projects/pea...apo-extension/

as a "system-wide" EQ - can be activated and DEactivated easily.

Thanks. This is preliminary, but... I especially needed the "Pre
Amplifying" function. Was not getting enough volume out of my
system.

Been using it ever since.