On 2/8/2018 4:18 PM, Scott Dorsey wrote:
Linda Masterson wrote:
How would I wire this with a single conductor? Remember I am wanting to split the signal into two 1/4" TS connectors for stereo. Headphone out to two TS 1/4".
Tip on the TRS to center conductor of wire 1 to tip of TS #1.
Ring on the TRS to center conductor of wire 2 to tip of TS #1.
Sleeve on the TRS to both shields to sleeves of both TS #1 and TS #2.
BUT..... your hum problem is almost certainly caused by a ground loop and
will continue no matter how it's wired, unless you can find a way to lift
the ground connections between the instrument and the console. A DI can
make this foolproof but you can likely do it using your existing cable
with pin 1 lifted on the XLR ends so the ground floats.
--scott
Thanks Scott and very interesting. Please remember I am cranking the
gain and being ultra particular about noise which sounds like hum.
The Livewire interconnect cable helped considerably and was acceptable
to my ears but i was hoping to return it because it is too short and it
was the longest Guitar Center had for this situation.
http://www.guitarcenter.com/Livewire...1-4-TS-Male.gc