[Nate Najar]

On Wednesday, June 10, 2015 at 12:23:06 AM UTC-4, PStamler wrote:
Congratulations on the good results. The instrument inputs on some interfaces will indeed work for this, as long as there are two of them (a lot of interfaces just have one). If you plan to do this again you might want to look up the input impedance of those instrument inputs and use a Y-connector to add some parallel resistance to bring it down to 47k, which is what the cartridge wants to see.

I just looked it up, it's 1meg. I didn't realize that cartridge wanted an impedance that low.

The line inputs are 14.5K and the mic press are 5.5K


iZotope RX has a pretty decent scratch and crackle treatment; start out with it set to about 1.2, and increase as needed.

that's good to know. I don't actually have the izotope software. I use a program called "sample manager" which uses the izotope algorithm for SRC.


Peace,
Paul