Gain Change on Shure MX418
"Mike Rivers" wrote in message
On 12/2/2010 9:56 PM, mcp6453 wrote:
On to my question. The Shure MX418 spec sheet says that
the output level can be set to 0, but it is shipped as
+12. In looking at the spec sheet, it appears that the
gain changes require soldering surface mount resistors:
12 dB of gain isn't a whole lot, but it's sometimes
helpful on a podium mic like this.
Pedant mode on
Since you're a published author Mike, I'll save you a little grief down the
road by reminding you that this is a lectern mic, not a podium mic. ;-)
I'm sure that there isn't a editor left in the business who knows the
difference, but there may be at least one of your many readers who does....
Pedant mode off
|