[Bret L]

On Jun 1, 8:12*pm, "Shhhh!!!! I'm Listening to Reason!"
wrote:
On Jun 1, 5:40*pm, Bret L wrote:

and have no METHODOLOGY
*Clear and concise procedures are no where to be found.

Go ahead. Post the "clear and concise" procedures and the METHODOLOGY.

I actually don't have a methodology or a fixed procedure. But at
least I KNOW I am lacking this important information (and seek to
correct this deficiency) whereas the high enders both lack it and the
knowledge that it is necessary.

As for "any modern pre will work", yes, after a fashion it will.

Permanently soldered components-the right ones once you know what
they are-are an advantage over DIP or panel rotary, or even the relays
used for remote controlled settings. That's why optimum results mean
you have to be able to solder. Optimum, means the best possible.
Consumerized solutions can approach but never achieve it since they
have to accomodate all contingencies.