Dolby B/C software?
"Arny Krueger" wrote in message
...
(2) It appears that the software Dolby B decoder is set up so that Dolby
level = digital full scale. So, I would find out how much amplification I
had to apply in the digital domain to get the tone I recorded off the
calibration tape to be FS. I would then apply that much gain to any tapes
I
transcribe, before passing them through the software Dolby digital
decoder.
Oh dear. That's bad news, since very often tapes have signal recorded at
higher than Dolby level. What was in on cassettes, 185nW/m? Or 250?
Peace,
Paul
|