On Tue, 28 Oct 2008 03:22:50 +0000, Eeyore
wrote:
Frank Stearns wrote:
Then there's the whole issue of getting out your SMD rework solder station and
putting it in, without breaking the new chip or something else in the process.
Bah !
You can do it with a TCP and a fine but hot (800) tip. Remember the old one is junk so
need to save that, cut all the pins and remove individually. Clean up with Soder-Wick
and isopropyl alcohol and solder in the new part.
Graham
Thanks to an exraordinarily generous offer from Tom Jancauskas of
Imedia Recording in IL, a solution has been found. Thanks again,
Tom.
Rick Ruskin
Lion Dog Music - Seattle WA
http://liondogmusic.com
http://www.myspace.com/rickruskin