View Single Post
  #4   Report Post  
Posted to rec.audio.opinion
Trevor Wilson[_2_] Trevor Wilson[_2_] is offline
external usenet poster
 
Posts: 724
Default ONE repair in all my years...


"MiNe 109" wrote in message
...
In article ,
"Trevor Wilson" wrote:

"MiNe 109" wrote in message
...
In article

et,
Jenn wrote:

...of listening to music through home audio equipment. In about 35
years, for all of the gear I've had, from Sears on up, I've had a
power
switch on a SAE amp go out after 3 years of use in 1983. That's it.
Am
I lucky, or do you have similar experiences?

I was surprised to learn that my Linn electronic crossover required
more
than one hundred fifty replacement capacitors. Then I found my Linn amp
needed a similar action when I plugged in the newly repaired crossover.

The capacitors on my LP12 power supply died a couple of years back. I
wonder if these Linn capacitor failures are a coincidence.


**Read the specs on capacitors sometime. It's quite scarey. Electrolytic
caps are usually rated to XXXX hrs @ 85oC or 105oC. The better the cap,
the
more hours and the higher the temp. Naturally, the cap is derated, as the
temperature rises. A typical cap found in a domestic product would be
rated
for around 5,000 hours @ 85oC. A mil-spec cap might be typically 20,000
hours @ 105oC. The difference in cost would be substantial. Keep your
caps
cool. Fan cooling is best.


My repairman used mil-spec replacements for about the same price Linn
would have charged to renew the original parts.


**That'd be about right.


I think I'll go turn off some amps now.


**Good idea. And next time some idiot tells you to keep your amp switched
on, send them the repair bill.

Trevor Wilson