[Mike Rivers]

On Jul 9, 5:14 pm, Tom Sullivan wrote:

I took the machine apart and the problem seems to be with the FFD and
RWD
modes of the machine. It works in play mode and it will scrub fwd and
back in play mode, but when put into FF or RWD, the head keeps spinning
but the tape sprockets (small reels) do not turn.

Replacing belts and cleaning might get it back to working condition
again, but you might be better off just putting it on the shelf and
finding another DAT deck that works to take care of this project. It's
not likely is it, that you'll continue mixing to DAT? If you send it
to Eddie Ciletti or Pro Digital it'll probably cost you $250-$400 to
have it repaired, if it actually can be repaired. I'd think that
working DATs should be going for under $200 through eBay. As long as
you buy from a seller who will guarantee your satisfaction, you should
be safe.

Please email, as I rarely check this forum these days (not enough time
to read them all anymore!).

Yes, that is kind of rude. Even with kids and a job, you can check a
newsgroup every couple of days for replies. You don't have to read
every message in the newsgroup, just look for this thead and it will
only take you a few seconds to see if anyone has a useful suggestion
for you. It's polite to reply to at least the significant posts, but
not required.