Chung said;

"For there to be "more current flow" with one cable, there has to be more
voltage measured across the load. Why is this difficult to see?"

Drugs in my younger days, I have the flue, I really do, had a flue shot, but
that was a waste. I was thinking about a music signal into a full range
speaker.

"Are you saying that there can be more current flowing into the load with
the *same* measured voltage across the load? Does "impedance" mean
anything to you?"

I have already addressed this in another post, there is no need to argue it
in 2 posts.

You realize that we are not comparing speakers. We are talking about
differences in bass response between two cables.

Actually I was thinking of IC's between components more than speaker cables,
once you get into a good cable, I have not tried 12 gage wire so I cannot
comment, but once you get into a Goertz, Kimber, Monster, et. al. I cannot
hear a difference, but I have heard differences in IC's.
--
Best Regards,

Lou
"chung" wrote in message
...
Lou wrote:
They have letters from men, they are engineers. I know not if they are
"registered" what ever that means. Not much emphasis seems to be placed
upon
analogue these days in the schools, or at least that is what they tell
me.

" No, you misunderstand the basics here, as the *impedance* of the load
will vary dramatically in the bass region, thereby affecting how much
power is required for a given SPL. It is therefore a moot point
whether the load will require more amps or more volts at any
particular frequency."

Someone sure is misunderstanding someone here... If you claim that an IC
gives you more bass, sure you can compare the current in the 2 ICs, but
the
only way to know would be to filter out the low frequencies where it is
said
they are hearing more bass, and see if there is in fact more current
flow
there.

For there to be "more current flow" with one cable, there has to be more
voltage measured across the load. Why is this difficult to see?

Are you saying that there can be more current flowing into the load with
the *same* measured voltage across the load? Does "impedance" mean
anything to you?

You realize that we are not comparing speakers. We are talking about
differences in bass response between two cables.



--