[Carey Carlan]

"Richard Crowley" wrote in
:

"Carey Carlan" wrote ...
So the phantom power circuit is not adding noise. Is it providing
enough voltage? A voltmeter across pins 2 and 3 should read 48 VDC.

Actually from pin 1 (ground) to pin 2 should read 48VDC,
and from pin 1 to pin 3 should read 48 VDC. You should
see NO voltage between pins 2 and 3. Minor slip in an
otherwise excelent piece of advice.

Yup. I should never discuss terminating resistors and phantom voltages in
the same message.