Thanks Pat,
I was afraid of just such a situation... I can't even get my hands on an AC202
(DIN to RCA adapter), much less an AC206 and two AC201's... Unfortunately, I
passed on tony's (tbird1950) offer on a couple of AC201's and now they're long
gone.
I'm afraid I'll have to go another route, using the three way standard set-up,
overpowering my tweeters, and under powering my mids...
I tried calling the woman you put me in contact with last time we spoke, but got
no resopnse. Perhaps she's gone now too...
I'll try the standard config, and let you know how it turns out.
Thanks again Pat, a/d/s/ is surely missing your expertise and helpfulness.
Keith

Pat M wrote:

Yes it can be done but you will need to get your hands on an AC206 which is
a router for the din pins. You will need one of those and then 2 AC201's I
believe are the part #'s. They are the 1' male din to din connectors. This
will allow you to run the din pins to the respective locations. If you use
the diagram in the manual and just plug the modules in the wrong locations
it will only cause problems. It is not that simple. This will then allow
you to run channel 1 input to bridge channels 1/2, then channel 3 input to
bridge channels 3/4 and then channels 5/6 in a stereo operation.

As for not getting service, parts, responses to emails or anything else from
a/d/s/ you need to keep in mind that the individuals that were there 6
months ago are no longer there. Directed is now doing everything out of
their own facility in Vista and the individuals that worked out of the
Phoenix and Boston facility well are no longer around. I guess they
thought it would be better but it seems like their are some good things
about it and definitely bad but when it comes to old school stuff you are
pretty much well tossed on the side.

If you have any questions just let me know.
--
Pat M.

"keith" wrote in message
...
Hi,
I'd think that this should be pretty simple, but the manual for the
642ix doesn't list it as an option... This set-up is going in a Toyota
king cab, with stealth being a priority (I'd REALLY like to keep it down
to the one amp)...

I want to run ch's 1&2, and 3&4 of the PH15 bridged to a set of Morel
components (I really do need all of those 100 watts for each side), and
then I want to use ch's 5&6 to run a pair of old school JBL 8" free air
subs (very efficient) from ~200hz down. The closest configuration
listed is exactly the opposite... 100WRMS x2 for the subs, and 50WRMSx2
for the components.
Am I gonna have to build my own modules here? I haven't had any luck
with getting service, parts, answers or even basic email responses from
a/d/s/... As much as I love Directed, a/d/s/ just isn't even colse to
the same company after the buy-out - sorry, different rant...
TIA,
Keith