No, I'm using a 642ix... The loads are right, but I can't seem to get access to
the optional modules that it looks like I need... I'm hopong that there's a
jumper/standard module combination that will get me there... Additionally, the
units are connected via the 8 pin DIN wire, that restricts easy switching of
input sources. No, the PH15 doesn't have an internal x-over. That'd just be
too simple...
Thank you for input,
Keith

james w wrote:

It should work just fine. The amp doesn't care what you connect to it as
long as the load is with in operating specs. Just have to make sure the
crossover is right. On my 640.2, the crossover is weird - the 1-2 channels
only do a high pass though they can be set to be controlled by the 3-4
crossover. It's been a long time since I've had a ph15, does it even have a
cross over? Or, are you usinghthe 642csi?

"keith" wrote in message
...
Hi,
I'd think that this should be pretty simple, but the manual for the
642ix doesn't list it as an option... This set-up is going in a Toyota
king cab, with stealth being a priority (I'd REALLY like to keep it down
to the one amp)...

I want to run ch's 1&2, and 3&4 of the PH15 bridged to a set of Morel
components (I really do need all of those 100 watts for each side), and
then I want to use ch's 5&6 to run a pair of old school JBL 8" free air
subs (very efficient) from ~200hz down. The closest configuration
listed is exactly the opposite... 100WRMS x2 for the subs, and 50WRMSx2
for the components.
Am I gonna have to build my own modules here? I haven't had any luck
with getting service, parts, answers or even basic email responses from
a/d/s/... As much as I love Directed, a/d/s/ just isn't even colse to
the same company after the buy-out - sorry, different rant...
TIA,
Keith