"KU40" wrote in message
...

is there a factory grill over the spot? How much more room do you have
before the front of the speaker hits the grill? if it's enough room,
make yourself some new mounting rings out of wood to put in there that
would push the speaker out enough.


--
KU40

Ditto, like this,

http://s6.photobucket.com/albums/y23...t=HPIM1979.jpg

I made them 1.5" thick measured them out to see how much i needed to trim
back so the door card would go back on then trimmed on a table saw
CAREFULLY.

At full excursion the speaker clears the door card by about 3MM and the
magnet is about 1/4" from the window edge when down.

Here's the rings on my rednek drying station

http://s6.photobucket.com/albums/y23...t=HPIM1956.jpg

Chad