"Arny Krueger" wrote in message
...
: "WillBrink" wrote in
: message
:
: In article
: .com,
: wrote:
:
: Grounding your speakers for better sound: This only
: requires some spare light gauge copper wire and
: soldering equipment. It's for advanced audiophiles who
: are not afraid to go into their (dynamic) speakers. Cut
: single lengths of wire about the length of your regular
: speaker wire. Solder each piece of wire to the positive
: terminals of each driver connected to the crossover
: board inside the speaker. Do the same for the other
: speaker. Now combine the free ends of all 4 (or 6)
: wires, and connect this to the terminal grounding screw
: at the back of your amp.
:
: And the proof this silly tweak will have any effects on
: sound quality is where again?
:
: It's obvious - by muting most if not all of the drivers in your speaker
: system and possibly destroying your power amp, audible distortion and noise
: will be dramatically reduced.

amazingly enough, exactly what i thought here
proves it _is_ possible that i agree with Arny
:-)
Rudy