On Sat, 17 Dec 2005 15:43:11 GMT, Adam Stouffer
wrote:

Has anyone ever bought laminations from a place called Tempel Magnetics?

http://www.tempel.com/

http://www.tempel.com/products/tld/Elkeepers/ei150.html

They are sending me a quote for a quantity of EI-150 M6 laminations. The
smallest amount they can quote is 33 pounds of lams. I will post the
price when they send it.

Is an EI-150 core a good size for a SE 6C33? I figure with the low turns
ratio it should be a good first transformer. For anyone who hasn't seen
this check out the OPT calculator.

http://geek.scorpiorising.ca/yves.html



Adam

Tempel is a very reputable company. They are
the largest lamination company in North and South
America. Their sales volume is over $260,000,000
per year. They are a large supplier to the motor industry
as well as the transformer industry. They have been a
supplier to us since 1953. Their anneal cycles are
very good especially on the grain oriented material.
All is hydrogen annealed in very long tunnel ovens. The
tooling is quite good. Very little burr on the lams.

Jerry