MD wrote:
I use the unit on tape out of my int amp


I have huge room bumps at 48hz, 68hz and 130hz- the unit works great to
fix these with no negative side effects - especially in the highs - chan
separation - EXCEPT - it adds white noise on its output (I can tell it's
the output because I can disengage the filters and the noise is there -
as well as try to use the filters to find the noise - which I cannot.
It is barely noticeable with a CD input - but there - and very obvious
when I use phono (lower level input).

The specs say noise is less than -94db. This doesn't make sense

Is this because I am running single ended?

Is there a way to bump up the input level of the device to increase the
sig/noise ratio?

I have two Behringer equaliser units=both noiseless. One former unit
failed within two months of purchase. Behringer distributors in
Seattle-Edmonds first had it repaired and mailed there and back with no
expense to me and then when the repair failed replaced it with a brand
new unit- still no costs. Later without asking I was sent an upgraded
chip for the unit when it became available.
My experience with them was excellent. Why don't you contact them in
Edmonds Wa. instead of trying this and that?.
Ludovic Mirabel