"Jeste" wrote in message
om...
Hi all,

I'm doing some multi-track recording using a tascam us-122 over USB
with Adobe Audition 1.5.

I find that if I use the computer's internal soundcard to monitor the
mix, the signal being recorded matches well with the existing mix.
However, using the us-122's direct monitoring to monitor the mix
results in a noticeable timing mismatch between the recorded signal
and the existing mix.

Is there a way to compensate for this latency? I've tried changing
the buffer settings in the us-122's control panel but this does not
appear to affect the latency I'm experiencing.

Any ideas?

Thanks,
Jeste.


I've never used to US122 so I'm kinda flying blind here. A quick look
at the manual didn't reveal much either. The only thing I could find
was reference to the "Direct monitor" switch. Overdubbing with that
switched off could cause the problem you're describing.

If I'm even understanding your problem correctly. Are you saying that
you hear yourself delayed while you're playing, or that the tracks don't
line up in your software after recording?

--
"It CAN'T be too loud... some of the red lights aren't even on yet!"
- Lorin David Schultz
in the control room
making even bad news sound good

(Remove spamblock to reply)