Dennis Selwa wrote:
Hey home brewers,
I'm looking for some nice ways to point to point wire my preamp.
I've built lots of Heathkits , Knightkits , Eicokits etc. back in the
fifties and sixties. The typical method of point to point wiring then
was to use mounting strips that had between two and six terminals
that were made of stamped out metal and phenolic.
A couple of the nicer methods I've seen was in a Mac MC60 and HK
Citation II. They used boards with terminal pins which I liked a lot.

Ok I'm looking for some nice modern ways to mount my circuitry.
Can Anyone give some sources of terminals and user friendly parts for
the home brewer?

Dennis Selwa

I usually use the tradtional terminal strips, not because they're
traditional but because they're easy to use, and relatively inexpensive
and readily available.

Cheers,
Fred
--
+--------------------------------------------+
| Music: http://www3.telus.net/dogstarmusic/ |
| Projects, Vacuum Tubes & other stuff: |
| http://www.dogstar.dantimax.dk |
+--------------------------------------------+