rowdy yates wrwer wrote:
Morning men. Is there a known issue with the Tanberg 3008-A preamp?
Any possibility of a language problem in silk screening the phono
inputs? A mix-up? A faux pas? From the schematic, and from a signal
trace, I see the input labeled MM (moving magnet) has an elaborate
selective loading scheme you sometimes see on MC inputs. Separate
loading for each channel even. (any idea why someone would do that?)

Because MM cartridges generally sound very different with different
loading. There are a few, like the Decca ones, which are even specified
for something other than 47k loading.

If you measure the input resistance with a meter, you'll find it's adjustable
but probably in the 25-75 kohm region. (I am assuming most of the load is
from the shunt resistance).

This is a very nice thing to have.

The input labeled MC (moving coil) has a much more standard input in
terms of circuitry.

Yes, but what is the input impedance? I bet it is a whole lot lower
than the MM input Z. Again, measure the resistance and assume that the
resistance is the dominant part of the load.

I repaired my channel (problem was not part of the
riaa inputs) and when I hooked up a turntable to the MM input it
sounded terrible, no bass, squawky- something definitely screwed. I
called Grado and talked to the engineer who designed the Signature
8MZV cartridge and was told it is definitely a MM device. If I plug it
into the input labeled MC it sounds fine. (he says, "so leave it
there,..". That's the way they approach these things in NY- out here
we have science!) I was wondering if anyone had come across this
before in the Tanberg line. Thank you for your time.

What load impedance does it call for on the data sheet? What load
impedance is the MM input on the Tandberg strapped for? What load
impedance is the MC input strapped for?

No bass and sqawky would tend to make me thing the load impedance is
too high and the cartridge is ringing.
--scott


--
"C'est un Nagra. C'est suisse, et tres, tres precis."