AudioBanter.com - View Single Post

In article writes:

Mackie provided a mod kit and instructions - been done. While the
retro**** did lower the spurious racket from the woofer it didn't get
near acceptable levels. But the new ones I auditioned at a GC in Austin
earlier this week are dead quiet, wooferly speaking, with a remaining
low level tweeter hiss. All in all the current production seems ready
for primetime.

There was a time when Mackie would replace your speakers with new
ones. Have you asked?

The automatic loudness compensation is knee'd at
about 157 Hz, Q of 1.1 and boost of _8 dB_.

If you know what to snip, you know what to switch. Is there a place
you could mount a switch? On the other hand, it sounds like either
you'd want it or you wouldn't, so you could take it out and never miss
it.

--
I'm really Mike Rivers )
However, until the spam goes away or Hell freezes over,
lots of IP addresses are blocked from this system. If
you e-mail me and it bounces, use your secret decoder ring
and reach me he double-m-eleven-double-zero at yahoo