Are they easy to replace ? When I look at taking the back off of the mixer,
it looks like I have to unscrew all of the TSR nuts, but as long as the TSR
sockets themselves remain in place then I guess thats do-able. Anybody done
this before ? Electronics is part of my job so I'm not too afraid of taking
it apart.... honest !

Cheers,

Mark.
--

"Mike Rivers" wrote in message
news:znr1103066676k@trad...

In article
writes:

I've noticed a slight problem on the first fader of my new Crest XR20.
When
you move the fader past the "30" marking, I feel a slight resistance and
a
"clicky" kind of feel and noise. It doesn't seem to affect the audio at
all.

It probably will, eventually, and the fader will need to be replaced.
If you don't get a response from your e-mail fairly soon, call them.
If the mixer is farily new and you didn't pour beer into it, they'll
probably send you a replacement fader.


--
I'm really Mike Rivers )
However, until the spam goes away or Hell freezes over,
lots of IP addresses are blocked from this system. If
you e-mail me and it bounces, use your secret decoder ring
and reach me he double-m-eleven-double-zero at yahoo