"Richard Crowley" wrote in message
...
"GaryMedia" wrote in message
m...

The mixer end is TRS with T=Send and R=Return and S=Ground
The other end going into the DAW is an unbalanced TS connection.

So, the T and S shorted on the mixer side, and connected to T on the
other
end?...then of course the S on both ends is common. Right?

That is how I wired mine and they work just fine.

Surely not?
You should short Tip and *RING* at the mixer, then connect to the tip at the
DAW.
Both sleeves are common or ground.

TonyP.