AudioBanter.com - View Single Post

In article writes:

For a one-off panel, there are a couple of techniques that might work
for you.

1. Mechanical engrave & fill.

2. Photo-engrave.

I suspect that the original poster has a situation like I do, and
probably a lot of people who have older equipment that gets handled a
lot. Many of the legends on my Soundcraft console are worn off. It's
quite impractical to remove the front panel from each worn module (at
least they're all on modules, which I can't say for my Mackie mixer)
and have them engraved.

I tried using some dry transfer lettering covered over with clear
tape, but that didn't look very good. I've looked into those Brother
(and the like) label makers that print on laminated tape, but none of
them have small and delicate enough fonts to fit in the tight space.

A good memory helps.

--
I'm really Mike Rivers )
However, until the spam goes away or Hell freezes over,
lots of IP addresses are blocked from this system. If
you e-mail me and it bounces, use your secret decoder ring
and reach me he double-m-eleven-double-zero at yahoo