Bob Urz:
Unless you accidentally bent a spring contact or there was an error when you
re-assembled the control or there is a lifted trace on the pcb...... the
repair control should work perfectly..... you may want to double-check
things. ..... or as the reply post by Mark D. Zacharias pointed out, you
could install a new part.
I have fixed dozens and dozens of these controls without a callback or
failure.
--
Best Regards,
Daniel Sofie
Electronics Supply & Repair
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -



"BOB URZ" wrote in message

Well, it was as you said. Mechanical encoder. cleaned some of the gunk
off,
pulled out the contracts slightly. Put it back together.
Now, it does not want to turn up like it was. So i guess its new
control time or junk time. Well see if Andrews answers my faxes this
time.

Thanks for the help all.