In article writes:

Screen shots were taken and put in the following ZIP file:
http://www.audiorail.com/ADA8000_test.zip (size = 688 KB)

Steady state FFT scans show roughly 70 dB S/N ratio at the +4 dB
setting, reducing to roughly 40 dB S/N ratio at maximum trim
sensitivity.

The Audiorail guy has been posting to the Pro Audio list lately, and
mentioned this converter as a low cost companion to their Ethernet
snake system. He said it was "OK for PA use" but the response from an
installer said that if he included a piece of Bearrooger gear in a
proposal, he might as well toss it (the proposal) directly into the
trash and save the potential client the trouble. Apparently in the
sound contracting world, it just isn't taken seriously.


--
I'm really Mike Rivers - )
However, until the spam goes away or Hell freezes over,
lots of IP addresses are blocked from this system. If
you e-mail me and it bounces, use your secret decoder ring
and reach me he double-m-eleven-double-zero at yahoo