Hi All.
I just had a run through of my recently renovated studio control room with a
Rane RTA/pink noise gen.
Basically I sent the pink noise through the mixer/monitors placed the test
mic (came with the rta) at mix position. checked the volume with a dbmeter
at around 85 db C weighted, and set the rta for same.
What I see is basically flat (at 3db window) response from 63 hz to 2.5 khz,
but then all above 2.5 khz drops off the meter after that.
Question : Am I doing this correctly? The room sounds fairly live (not
completely dead), I would have thought the high frequency stuff would be
flat also to a certain point.

Should I adjust the high end response (3db boost 2.3 khz shelf) on my Event
20/20ps?
And how should I calibrate my subwoofer? I set its crossover at about 80 hz
or so but it still sees some frequenceis above that point no matter what the
crossover is set to.
I want to make things better not worse.
Any suggestions?

Cheers,


--
Jason

www.JasonWhelan.com