Nicholas Malboeuf
April 14th 06, 04:39 PM
I have the following collection of car audio odds and ends and would like
some help setting them up, and to see if there are any thing else I may
need, gotta love eBay prices
also is there any where I can read on how to figure this **** out more? I
know some , but not much
head unit - Alpine CDA-9827
Bass Engine (bass center frequency, width, and level, plus treble center
frequency and level adjustments)
optional auxiliary input
MOSFET internal amp
4-volt front, rear, and subwoofer preamp outputs
18 watts RMS/50 peak x 4 channels (CEA compliant)
Amps (x2)
kicker KX300.4
75W x 4 @ 2 Ohms RMS
38W x 4 @ 4 Ohms RMS
150W x 2 @ 4 Ohms RMS mono bridged
3 channel mode: 38W x 2 RMS + 150W RMS mono
Frequency Response: 20Hz-20kHz; +0, -1dB
Input Sensitivity: High Level 340mV-10V, Low Level 170mV-5V
Signal-to-Noise Ratio: >95dB, a-weighted, re:rated power
Active Crossover: Variable high or low pass, 50-200 Hz, 12db/octave
KICKEQ Bass Boost: Variable to +18dB, centered @ 40Hz Pass-Thru RCAs
Remote Bass Control (dash mountable)
8 gauge Power Wire input. 40 Amp fuse rating
Protection built-in
Audio Gods AMOS 4.8A2X
MOSFET 4CH 800WATTS DIGITAL CLASS"A" AMPLIFIER
ACTIVE, 2 WAY ELECTRONIC CROSS OVER BI-AMP SYSTEM
speakers
2 Clarion srr1615 160wat max, 35 wat continuos
2 6x9 Alpines i think, they in the truck so not sure, but sound great off
the deck by them selves
Subs
4 Kicker ST100 10" subs
Subs go down to 41 hz
handle 75 watts RMS each
4 ohm impedence
now before I bought the kicker subs and amp off eBay I had and idea of what
I was using, so now I'm thinking I run the 800 4 channel amp to the 4 subs
and the lil kicker to the speakers, but I'm clueless about the cross over if
I need one or if the amps have them built in, cause I see the alpine deck
has a feature for it, while the kick and the audio god seem to have
something about that as well
I would like to run both amps or maybe sell them for a proper amp, but then
I need to know what I need to do now for the speakers and subs, I had the
audio god hooked up to the clairons speakers with a friend's MA Audio 2 12"
subs and box and the 6x9 into the deck, but I remember I had a few choices
for hooking up the subs, two channels combined to feed more watts I think to
the dubs and the 2 12s were mega wicked
so maybe my amps will do with the 4 10" subs? I'll just need to figure what
channels now go where and what to plug into what
any help would be greatly welcome
some help setting them up, and to see if there are any thing else I may
need, gotta love eBay prices
also is there any where I can read on how to figure this **** out more? I
know some , but not much
head unit - Alpine CDA-9827
Bass Engine (bass center frequency, width, and level, plus treble center
frequency and level adjustments)
optional auxiliary input
MOSFET internal amp
4-volt front, rear, and subwoofer preamp outputs
18 watts RMS/50 peak x 4 channels (CEA compliant)
Amps (x2)
kicker KX300.4
75W x 4 @ 2 Ohms RMS
38W x 4 @ 4 Ohms RMS
150W x 2 @ 4 Ohms RMS mono bridged
3 channel mode: 38W x 2 RMS + 150W RMS mono
Frequency Response: 20Hz-20kHz; +0, -1dB
Input Sensitivity: High Level 340mV-10V, Low Level 170mV-5V
Signal-to-Noise Ratio: >95dB, a-weighted, re:rated power
Active Crossover: Variable high or low pass, 50-200 Hz, 12db/octave
KICKEQ Bass Boost: Variable to +18dB, centered @ 40Hz Pass-Thru RCAs
Remote Bass Control (dash mountable)
8 gauge Power Wire input. 40 Amp fuse rating
Protection built-in
Audio Gods AMOS 4.8A2X
MOSFET 4CH 800WATTS DIGITAL CLASS"A" AMPLIFIER
ACTIVE, 2 WAY ELECTRONIC CROSS OVER BI-AMP SYSTEM
speakers
2 Clarion srr1615 160wat max, 35 wat continuos
2 6x9 Alpines i think, they in the truck so not sure, but sound great off
the deck by them selves
Subs
4 Kicker ST100 10" subs
Subs go down to 41 hz
handle 75 watts RMS each
4 ohm impedence
now before I bought the kicker subs and amp off eBay I had and idea of what
I was using, so now I'm thinking I run the 800 4 channel amp to the 4 subs
and the lil kicker to the speakers, but I'm clueless about the cross over if
I need one or if the amps have them built in, cause I see the alpine deck
has a feature for it, while the kick and the audio god seem to have
something about that as well
I would like to run both amps or maybe sell them for a proper amp, but then
I need to know what I need to do now for the speakers and subs, I had the
audio god hooked up to the clairons speakers with a friend's MA Audio 2 12"
subs and box and the 6x9 into the deck, but I remember I had a few choices
for hooking up the subs, two channels combined to feed more watts I think to
the dubs and the 2 12s were mega wicked
so maybe my amps will do with the 4 10" subs? I'll just need to figure what
channels now go where and what to plug into what
any help would be greatly welcome