Nicholas Malboeuf
April 14th 06, 04:26 PM
I have the following collection of car audio odds and ends and would like some help setting them up, and to see if there are any thing else I may need, gotta love eBay prices
also is there any where I can read on how to figure this **** out more? I know some , but not much
head unit - Alpine CDA-9827
Bass Engine (bass center frequency, width, and level, plus treble center frequency and level adjustments)
optional auxiliary input
MOSFET internal amp
4-volt front, rear, and subwoofer preamp outputs
18 watts RMS/50 peak x 4 channels (CEA compliant)
Amps (x2)
kicker KX300.4
75W x 4 @ 2 Ohms RMS
38W x 4 @ 4 Ohms RMS
150W x 2 @ 4 Ohms RMS mono bridged
3 channel mode: 38W x 2 RMS + 150W RMS mono
Frequency Response: 20Hz-20kHz; +0, -1dB
Input Sensitivity: High Level 340mV-10V, Low Level 170mV-5V
Signal-to-Noise Ratio: >95dB, a-weighted, re:rated power
Active Crossover: Variable high or low pass, 50-200 Hz, 12db/octave
KICKEQ Bass Boost: Variable to +18dB, centered @ 40Hz Pass-Thru RCAs
Remote Bass Control (dash mountable)
8 gauge Power Wire input. 40 Amp fuse rating
Protection built-in
Audio Gods AMOS 4.8A2X
MOSFET 4CH 800WATTS DIGITAL CLASS"A" AMPLIFIER
ACTIVE, 2 WAY ELECTRONIC CROSS OVER BI-AMP SYSTEM
speakers
2 Clarion srr1615 160wat max, 35 wat continuos
2 6x9 Alpines i think, they in the truck so not sure, but sound great off the deck by them selves
Subs
4 Kicker ST100 10" subs
Subs go down to 41 hz
handle 75 watts RMS each
4 ohm impedence
now before I bought the kicker subs and amp off eBay I had and idea of what I was using, so now I'm thinking I run the 800 4 channel amp to the 4 subs and the lil kicker to the speakers, but I'm clueless about the cross over if I need one or if the amps have them built in, cause I see the alpine deck has a feature for it, while the kick and the audio god seem to have something about that as well
I would like to run both amps or maybe sell them for a proper amp, but then I need to know what I need to do now for the speakers and subs, I had the audio god hooked up to the clairons speakers with a friend's MA Audio 2 12" subs and box and the 6x9 into the deck, but I remember I had a few choices for hooking up the subs, two channels combined to feed more watts I think to the dubs and the 2 12s were mega wicked
so maybe my amps will do with the 4 10" subs? I'll just need to figure what channels now go where and what to plug into what
any help would be greatly welcome
also is there any where I can read on how to figure this **** out more? I know some , but not much
head unit - Alpine CDA-9827
Bass Engine (bass center frequency, width, and level, plus treble center frequency and level adjustments)
optional auxiliary input
MOSFET internal amp
4-volt front, rear, and subwoofer preamp outputs
18 watts RMS/50 peak x 4 channels (CEA compliant)
Amps (x2)
kicker KX300.4
75W x 4 @ 2 Ohms RMS
38W x 4 @ 4 Ohms RMS
150W x 2 @ 4 Ohms RMS mono bridged
3 channel mode: 38W x 2 RMS + 150W RMS mono
Frequency Response: 20Hz-20kHz; +0, -1dB
Input Sensitivity: High Level 340mV-10V, Low Level 170mV-5V
Signal-to-Noise Ratio: >95dB, a-weighted, re:rated power
Active Crossover: Variable high or low pass, 50-200 Hz, 12db/octave
KICKEQ Bass Boost: Variable to +18dB, centered @ 40Hz Pass-Thru RCAs
Remote Bass Control (dash mountable)
8 gauge Power Wire input. 40 Amp fuse rating
Protection built-in
Audio Gods AMOS 4.8A2X
MOSFET 4CH 800WATTS DIGITAL CLASS"A" AMPLIFIER
ACTIVE, 2 WAY ELECTRONIC CROSS OVER BI-AMP SYSTEM
speakers
2 Clarion srr1615 160wat max, 35 wat continuos
2 6x9 Alpines i think, they in the truck so not sure, but sound great off the deck by them selves
Subs
4 Kicker ST100 10" subs
Subs go down to 41 hz
handle 75 watts RMS each
4 ohm impedence
now before I bought the kicker subs and amp off eBay I had and idea of what I was using, so now I'm thinking I run the 800 4 channel amp to the 4 subs and the lil kicker to the speakers, but I'm clueless about the cross over if I need one or if the amps have them built in, cause I see the alpine deck has a feature for it, while the kick and the audio god seem to have something about that as well
I would like to run both amps or maybe sell them for a proper amp, but then I need to know what I need to do now for the speakers and subs, I had the audio god hooked up to the clairons speakers with a friend's MA Audio 2 12" subs and box and the 6x9 into the deck, but I remember I had a few choices for hooking up the subs, two channels combined to feed more watts I think to the dubs and the 2 12s were mega wicked
so maybe my amps will do with the 4 10" subs? I'll just need to figure what channels now go where and what to plug into what
any help would be greatly welcome