rane sm82 monitor question

[David Kakon]

hi:

i will be using a rane sm82 to monitor what goes into my lynx a/d. My
question is: I will be using a hedd for my d/a and want to mix in the
d/a to my monitor mix, will the output of the hedd be too hot for the
line inputs of the rane? The rane is a line mixer and the hedd outputs
at +4 dbm, will this be a mismatch? how can i porperly interface the
two?

thank you

david

[Mike Rivers]

In article > writes:

> i will be using a rane sm82 to monitor what goes into my lynx a/d.

> will the output of the hedd be too hot for the
> line inputs of the rane? The rane is a line mixer and the hedd outputs
> at +4 dbm, will this be a mismatch? how can i porperly interface the
> two?

It should be fine. If the HEDD has an output level control, you can
always turn it down.


--
I'm really Mike Rivers - )
However, until the spam goes away or Hell freezes over,
lots of IP addresses are blocked from this system. If
you e-mail me and it bounces, use your secret decoder ring
and reach me here: double-m-eleven-double-zero at yahoo

[David Kakon]

thanks for the reply. no the hedd has no volume control.

bet
david




(Mike Rivers) wrote in message news:<znr1069379327k@trad>...
> In article > writes:
>
> > i will be using a rane sm82 to monitor what goes into my lynx a/d.
>
> > will the output of the hedd be too hot for the
> > line inputs of the rane? The rane is a line mixer and the hedd outputs
> > at +4 dbm, will this be a mismatch? how can i porperly interface the
> > two?
>
> It should be fine. If the HEDD has an output level control, you can
> always turn it down.