I'm looking for any technical / repair data for the Bogen RF-35 stereo
receiver. It is an integrated unit using (4) 7408's (6v6-gt) and
point-to-point wiring.

After 5 years of pleasant service I now get zero output from the amplifier
stage (that means I've tested with phono, radio & aux) . All tubes test
good on my tester (which is not saying a lot... I only have a Eico 666).
I'm assuming my problem is in the preamp section & is probably capacitor
related. However, I have no data for voltage/ resistance test-points to go
by.

I couldn't find it listed on the Sam's Publications website... and searching
the web only turned up sporadic listings of units on auction sites.

My RAT experience is limited to rebuilding my Dynaco stuff. I have just the
typical testing equipment (the 666, a VTVM & a cheapie digital VOM)... no
scopes or anything like that.

Any data or first-hand experience would be greatly appreciated.

Kevin