Reply
 
Thread Tools Display Modes
  #1   Report Post  
Posted to rec.audio.car
mm mm is offline
external usenet poster
 
Posts: 5
Default AM car radio won't work unless someone touches the antenna

The car radio won't get AM unless one touches the antenna!

An internet acquaintance who still doesn't understand Usenet bought a
new radio for his Chrysler LeBaron, but AM reception was verrrrry low
volume, so as to be unusable. (FM is fine.)

He took it back to BestBuy and in the process of working on it, the
tech put his hand on the antenna and the volume went to normal and
reception was good.

He and the tech have concluded that he needs a new antenna, in place
of the one that has been there since the car was built, between 1990
and '95.

What are the odds this is true?

Or is the new radio likely defective?


Before 1965, I think it was, car radios had to have their antenna
"trimmed" to get good reception, by means of an antenna trimming
variable capacitor. In the Olds, there was an enlargement of the hole
under the on/off knob that gave access to a screw that adjusted the
trim. If touching the antenna increased radio volume, that meant the
antenna needed trimmming.

This is all I know about the electronics involved, but that may be
more than anyone else on the Chrysler yahoo list.

Is there a circuit that does this automatically today, that could be
broken in this new radio? Or has the need for trimming somehow been
eliminated? Or could the antenna be so bad that the radio can't
handle it.


Thanks for any help you can give him.
  #2   Report Post  
Posted to rec.audio.car
James James is offline
external usenet poster
 
Posts: 83
Default AM car radio won't work unless someone touches the antenna

Most likely, there is something wrong with the car antenna connections,
either at the radio itself, or at the chassis point where it is mounted.
It sounds like the antenna isn't property grounded.

I would first have him check and double check the plug point where the
antenna plugs into the radio. Make sure the plug is pushed all the way in.
Also, be aware that on many car radio setups, there is a 2-3 foot antenna
jumper wire which terminates in a female plug, and then then car antenna
male plug fits into that female plug. That joinder should also be checked
for tightness.

Lastly, the antenna mount should be checked , to make 100% sure that it is
grounded to the car chassis. If possible, remove the mount, scrap the paint
or crud from the car body, and remount the antenna.

Hope this helps. Please report back.

James


  #3   Report Post  
Posted to rec.audio.car
GregS[_3_] GregS[_3_] is offline
external usenet poster
 
Posts: 664
Default AM car radio won't work unless someone touches the antenna

In article , mm wrote:
The car radio won't get AM unless one touches the antenna!

An internet acquaintance who still doesn't understand Usenet bought a
new radio for his Chrysler LeBaron, but AM reception was verrrrry low
volume, so as to be unusable. (FM is fine.)

He took it back to BestBuy and in the process of working on it, the
tech put his hand on the antenna and the volume went to normal and
reception was good.

He and the tech have concluded that he needs a new antenna, in place
of the one that has been there since the car was built, between 1990
and '95.

What are the odds this is true?

Or is the new radio likely defective?


Before 1965, I think it was, car radios had to have their antenna
"trimmed" to get good reception, by means of an antenna trimming
variable capacitor. In the Olds, there was an enlargement of the hole
under the on/off knob that gave access to a screw that adjusted the
trim. If touching the antenna increased radio volume, that meant the
antenna needed trimmming.

This is all I know about the electronics involved, but that may be
more than anyone else on the Chrysler yahoo list.

Is there a circuit that does this automatically today, that could be
broken in this new radio? Or has the need for trimming somehow been
eliminated? Or could the antenna be so bad that the radio can't
handle it.


Thanks for any help you can give him.


All the old radios had a tunning slot in the back of the radio.
I don't know about the new ones. The antenna is a resonant system,
and needing a slightly longer antenna confirms this. There could possibly be a problem
with the feed to the antenna.

greg
  #4   Report Post  
Posted to rec.audio.car
mm mm is offline
external usenet poster
 
Posts: 5
Default AM car radio won't work unless someone touches the antenna

On Sun, 8 Nov 2009 21:26:28 -0500, "James"
wrote:

MM wrote:
The car radio won't get AM unless one touches the antenna!

An internet acquaintance who still doesn't understand Usenet bought a
new radio for his Chrysler LeBaron, but AM reception was verrrrry low
volume, so as to be unusable. (FM is fine.)

He took it back to BestBuy and in the process of working on it, the
tech put his hand on the antenna and the volume went to normal and
reception was good.

He and the tech have concluded that he needs a new antenna, in place
of the one that has been there since the car was built, between 1990
and '95.

What are the odds this is true?

Or is the new radio likely defective?


Before 1965, I think it was, car radios had to have their antenna
"trimmed" to get good reception, by means of an antenna trimming
variable capacitor. In the Olds, there was an enlargement of the hole
under the on/off knob that gave access to a screw that adjusted the
trim. If touching the antenna increased radio volume, that meant the
antenna needed trimmming.

This is all I know about the electronics involved, but that may be
more than anyone else on the Chrysler yahoo list.

Is there a circuit that does this automatically today, that could be
broken in this new radio? Or has the need for trimming somehow been
eliminated? Or could the antenna be so bad that the radio can't
handle it.


Thanks for any help you can give him.


Most likely, there is something wrong with the car antenna connections,
either at the radio itself, or at the chassis point where it is mounted.
It sounds like the antenna isn't property grounded.

I would first have him check and double check the plug point where the
antenna plugs into the radio. Make sure the plug is pushed all the way in.
Also, be aware that on many car radio setups, there is a 2-3 foot antenna
jumper wire which terminates in a female plug, and then then car antenna
male plug fits into that female plug. That joinder should also be checked
for tightness.

Lastly, the antenna mount should be checked , to make 100% sure that it is
grounded to the car chassis. If possible, remove the mount, scrap the paint
or crud from the car body, and remount the antenna.

Hope this helps. Please report back.


Sorry it took me so long. (that's why I restored my original question)
I was asking an open-ended question for someone else on a mailing
list. He wanted a new fancy car radio but the one he got had very low
volume, on AM, unless he touched the antenna. That sounded to me like
the antenna needed trimming (GregS made a reference to that.) and I
wanted him to read the manual and if it gave instructions for
trimming, to trim it, but he didn't get back to me on that.

Eventually he took it back to the store, which had installed it (at
first, he didn't tell us he'd had it installed) and they put in a new
antenna, and I'm sure charged him for that. Yet the antenna had
worked fine with the previous radio. I think one possibility was
that it was just chance that the new antenna worked with the new radio
and the old one didn't.

Or.... Apparently most radios don't have manual antenna trimming
anymore, but there is still automatic trimming needed to fit various
antennas. Maybe his radio was broken, or just didn't have that
circuit and only works with certain antennas. The latter is hard to
believe.

Anyone know more about this?

Thanks to you and to GregS for your replies.

James


Reply
Thread Tools
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Need good radio antenna ... which? Matt Car Audio 2 August 20th 05 07:18 PM
orange drop cap touches 12axy base NGS Tech 1 June 8th 05 10:08 PM
XM Radio at Home: Where does the antenna go? John Fleming Car Audio 1 May 12th 04 07:16 PM
Radio reception worse than factory radio, antenna adapter? AC/DCdude17 Car Audio 3 December 24th 03 03:17 PM
FM radio antenna height for car... ? NeilH011 Pro Audio 3 September 9th 03 11:47 PM


All times are GMT +1. The time now is 02:42 PM.

Powered by: vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AudioBanter.com.
The comments are property of their posters.
 

About Us

"It's about Audio and hi-fi"