The Soundcraft manual isn't too helpful and I don't have the Motu one. I'm
trying to connect these two via the 328's ADAT outputs.

Spirit Setup:
T.Send Dir enabled for all channels
24 bit, 48 kHz
8 Track A output to ADAT Bank 1 inputs on the 2408

324 Console setup:
Sample Rate: 48 kHz
Clock Source: Bank A Optical
Bank A: ADAT
Inputs are enabled

On the analog section of the 2408 the Src LED is solid red, both the 44.1
and 48 LED's are flashing red, and the Grp A is solid amber. I get no meter
LED's when running a source through it. I'm using Cool Edit Pro and I have
it set up to receive signal from the correct source, but nothing's there.
Any help would be greatly appreciated, especially if anyone knows where I
can find a PDF of the manual. The Motu site hasn't been too helpful.
Thanks a lot.

Thomas