[lewdslewrate]

Hi. I got tied in knots. It's a routing button for sure but i cant
find it: any help out there?
Set up: Focusrite ISA828 pre sending ADAT to AW2400 multi-track
recorder and same audio as analogue via Dsub to Yamaha o1v. O1v x4
aux out to headphones for musicians (monitoring on AW is limited at 24
bit and also a bit long winded with no fader layer etc). so..eg: i
send channel 1 to aux 1. i add reverb to ch 1 on home page but when i
pull down the ch 1 fader on the aux layer and the home (main ST input
page), i still get audio on aux channel due to effect fader even when
return is down. I tried pre/post buttons but no help. I suspect its
a basic error but pride before a fall etc
I want to give the musician some reverb in his headphones

[Ty Ford]

On Tue, 9 Aug 2011 11:37:25 -0400, lewdslewrate wrote
(in article
):

Hi. I got tied in knots. It's a routing button for sure but i cant
find it: any help out there?
Set up: Focusrite ISA828 pre sending ADAT to AW2400 multi-track
recorder and same audio as analogue via Dsub to Yamaha o1v. O1v x4
aux out to headphones for musicians (monitoring on AW is limited at 24
bit and also a bit long winded with no fader layer etc). so..eg: i
send channel 1 to aux 1. i add reverb to ch 1 on home page but when i
pull down the ch 1 fader on the aux layer and the home (main ST input
page), i still get audio on aux channel due to effect fader even when
return is down. I tried pre/post buttons but no help. I suspect its
a basic error but pride before a fall etc
I want to give the musician some reverb in his headphones

Maybe the send is pre fader. can you switch it to post fader?

Regards,

Ty Ford



--Audio Equipment Reviews Audio Production Services
Acting and Voiceover Demos http://www.tyford.com
Guitar player?:http://www.youtube.com/watch?v=yWaPRHMGhGA