Home |
Search |
Today's Posts |
#1
Posted to rec.audio.tech
|
|||
|
|||
Mac C-20 part needed
The 5 inch brass bracket that goes on the front side when not rack
mounting.The end cap.One needed. PLEASE.I don't wan to have to make one TIA Abbedd |
#2
Posted to rec.audio.tech
|
|||
|
|||
Mac C-20 part needed
ansermetniac wrote:
The 5 inch brass bracket that goes on the front side when not rack mounting.The end cap.One needed. PLEASE.I don't wan to have to make one TIA Abbedd Good morning, Do you mean the plastic end cap that goes over 2 pins on the front panel? Or is it a solid metal piece that mounts with 2 screws? Either way, I'd try contacting Audio Classics (www.audioclassics.com) to see if they might have one. You could also try McIntosh, but that is less likely. Regards, Tim Schwartz Bristol Electronics |
#3
Posted to rec.audio.tech
|
|||
|
|||
Mac C-20 part needed
On Fri, 28 Nov 2008 13:14:15 GMT, Tim Schwartz
wrote: ansermetniac wrote: The 5 inch brass bracket that goes on the front side when not rack mounting.The end cap.One needed. PLEASE.I don't wan to have to make one TIA Abbedd Good morning, Do you mean the plastic end cap that goes over 2 pins on the front panel? Or is it a solid metal piece that mounts with 2 screws? Either way, I'd try contacting Audio Classics (www.audioclassics.com) to see if they might have one. You could also try McIntosh, but that is less likely. Regards, Tim Schwartz Bristol Electronics Audio Classics does not have one It is brass but no screws Abbedd |
Reply |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Pioneer Part # needed | Car Audio | |||
Lexicon LXP-1 part needed. Help? | Pro Audio | |||
Lexicon LXP-1 part needed. Help? | Pro Audio | |||
Tandberg part needed | Tech | |||
Citation V Part Needed | Vacuum Tubes |